TUNDRA V3 NOTES

SA-RATES
SB-FLAPS
SF-THROT CUT
SG-REV THRUST
SH-TIMER RESET 

Receiver channel assignments

CH1 Ailerons
CH2 Elevator
CH3 Throttle
CH4 Rudder
CH5 Reverse thrust
CH6 Flaps

FLAPS
Flaps should be set up but please confirm flap travel and ensure that the servo isn't binding when fully up or down. Under MDL - OUTPUTS CH6, adjust MIN and MAX for flap end points if needed.

If when flying, the model balloons up or down when engaging the flaps, flight modes are enabled for elevator. Simply trim your elevator in Half Flaps and again on full flaps. Your elevator trim with flaps up will not be affected.

REVERSE THRUST
Connect the reverse thrust lead to channel 5. Reverse thrust is activated by the right momentary switch on the back of the radio. If it doesn't work, you may need to enable reverse thrust in the ESC. Please refer to the ESC documentation available on the HobbyKing website. 


Please confirm control surface directions before flying. Rates and expo should be adjusted to your personal preference after initial flight.
 


